Adding Lights to the Torment

[sowen12]

I purchased a set of lights from Sunshine Systems to add to the Torment. I have two 3-pin rows that I can plug into. One is labeled REV and the other BAT. I've tried both and the lights don't come on. The instructions aren't too detailed so I'm stuck. Any advice on where I would plug in the lights?

 

[mshell56118]

are you looking at the esc? those should have a jumper to choose whether you have reverse or not and the batt is to set between lipo or nmh. the lights need to hook up to the reciever, my Ruckus has a 3 pin marked aux on the receiver and this is where my lhs said the hook up would be for leds

 

[Reefguy89]

Yea your def looking at the jumpers on the esc. If you follow the 3 wires to another little box that is the reciever and that's where you would plug it in at.

 

[Shagz]

@sowen12 Do you have any pictures of the finished product

 

[Uglybassmike]

I want to put lights on my Torment as well. But, I do not think my stock receiver has any open spots to hook the lights up.

 

[Vivendus]

So disconnect the plug to the servo and run your LED wires in parallel with the servo. The power drain is negligible.

 

[Uglybassmike]

So disconnect the plug to the servo and run your LED wires in parallel with the servo. The power drain is negligible.

Thanks,

 

[Erequena1959]

I want to put lights on my Torment as well. But, I do not think my stock receiver has any open spots to hook the lights up.

You can also use a 9volt battery just get a plug for the 9 volt battery that way you don't use you power from your rc here's a pic

 

[Torment2WD0901]

 

[WoodiE]

View attachment 1848

those look perfect on that Torment. Nice job!