differential

Hey so I blew a tire on my 1/10 ruckus 4wd and I replaced the rear tires with a different set of the same size. The new tires didn’t balloon the same as my front tires and now I have a stripped diff. I can only find a complete diff but I only need the inside gears. You can buy the diff case and...

I had to replace the front/rear diff.gears after losing front wheel drive. And not even 2 months later im having to replace them again. Im running a 3s lipo. Has anyone had this problem? if anyone knows of a soution?

Okay I'm new to this and would greatly appreciate some help. I upgraded my 2wd Ruckus Monster truck motor and ESC to the 1/10 four pole 3000kv. First run strip metal gears in differential. I took it apart and replaced it with the plastic gears that were in it the beginning. Run it about 5...

Has anybody put diff oil in a standard diff? I just pull my diff apart and noticed there are no seals in there... I was going to put 10000wt in it.

About a week ago, I bought a ECX Torment 1/18 SCT and after a couple of times using it, i start to notice that the rear diff was acting strange. It felt like it was jamming, and when every time i accelerated the car, it made an awful gear grinding noise. I have taken off the rear diff to inspect...

So by upgrading to the Losi mini diff the part number says “diff housing “ does it mean the actual differential case or only the gears inside... I just don’t know weather to order the entire metal diff case or only the metal gears and use the plastic housing

i recently purchased a new 4x4 torment i am going to do the "cheap " brushless swap and swap to the metal differentials from the 1/14 losi mini and then pair with some metal axles that will fit if i can find any so this is the parts list for the metal gear diff swap my question is below 2x...

So... obviously plastic sucks.. but did this happen due to a slipper clutch being set to tight? I replaced it with metal gears, I still want to learn though. My friends that put my ECX AMP MT together for me and from what I could tell.. the slipper didn't slip at all so I think that is why it...

So I blew out both the diffs in my Temper thanks to a new motor. I ordered a couple of solid aluminum ones and installed them over the weekend. When I opened up the packages I realized the screws weren't even tightened all the way so I disassembled them and put some Loctite on the screws. I...

Does anyone know of or considered a spool in a 1/10 4wd ruckus? Locker maybe?

As many come to find out, the diffs in the mini ruckus don't stand up to much hard use. Within a few runs of the stock nimh pack I already had a 2wd truck. I ordered a new one for a quick fix and went looking for an upgrade. I shimmed the new one and it lasted longer but it still rounded the...